How To
|
 |
 |
 |
Note the before |
| |
|
 |
 |
Tools: The eyebrowz
brow comb/brush combo.
Directions: Remove all cosmetics from the brow, and brush or comb out
the brow hair. Dampen the brow hair. |
| |
|
 |
 |
Tools:
An eyebrow
stencil in a flat shape.
Optional eyebrowz stencil touch holder to help hold the stencil in position.
Directions: Lay the stencil down over the brow
hair. Slightly lifting the stencil comb all hairs above and outside the
stencil area into the stencil hole. The black arrow points to the hairs
that now are flattened to go "down". |
| |
|
 |
 |
Tools: Eyebrowz
brow comb/brush combo, extra firm hair spray, eyebrowz powder and
nylon powder brush.
Directions: Spray the brow brush with hair spray. Brush brow hair back towards the tail of the brow.
Hair at the front of the brow can be brushed up. Hair spray was given a
couple of minutes to dry. Powder was then used to
fill in the bald areas of the brow (on the bottom) - again using the
stencil as a guide. The powder was brushed slightly over the brow
hair to create continuity of color. This ensured no gap between the new
bottom edge of the brow and the brow hair. |
| |
|
 |
 |
-
hair at the front is brushed up
-
hair in the middle is brushed back
-
hair along the top is brushed down
-
powder has filled in the bottom section.
|
Stencil Catalogs
|
|
|
|
|
|
| Basic Shape Sketch |
|
|
|
|
|
|
- Some Tips & Tricks
-
Recreating your brow shape is not as hard as you may
think. It takes a bit of practise but it is well worth the
effort (as many beauties already know).
-
If you are starting from little brow hair it is as
simple as placing the stencil shape over your existing brows and
filling in with powder.
-
In all cases, we selected new brows that were one
step away only from the starting brow. For example, we went from
moderate arch to flat, from moderate arch to high arch. We did not
try to go to a high arch from a flat brow. We also went from medium
thickness to thick and thin. We did not try ultrathin. Thick to
ultrathin, for example, would have been too far a stretch without
removing hair.
-
We used a brow powder color similar to the hair
color. This makes it as hard as possible for anyone to tell where
the hair line ends and new brow area begins.
-
If your brow hair is very long consider using a
beard trimmer to trim your hairs to a good length - this will
prevent you from trimming them too short where they become
unmanageable
|
|
